This is how you can program a key to Fiat Ducato, Fiat 500L, Iveco Daily 2020+

1. You need to take out the BCM unit and open the plastic cover

2. Find the EEPROM and solder ZN057 as per the diagram on the next page

3. Read the SPI 95640 memory with ABProg - this will give you the PIN. This procedure is executed with the ZN130 ABProg programmer, and the ABProg upgraded software

4. Load the file into the FCA Software > Special Functions > Transponder Maker and prepare a transponder ID46 7936 (or 7946)

5. Proceed to Key Learning procedure

Required tools

• ZN130 ABProg programmer

• ZN057 EEPROM wire extender for ABPROG EEPROM/BCM adapter

• ZN103 ProTag Programmer

• CB019 would be required if the vehicle is equipped with a security gateway module

• In case there is a security gateway, but there is a problem with the communication with CB019 - ZN151 DS box and the CAN wires with the needle pinches need to be connected to the 6-14 ports of the DS Box and the internal CAN wires close to the BCM.

Internal CAN connection to the BCM, which is an alternative connection method for bypassing a gateway, whenever the procedure does not go trough while using the CB019. These are the CAN wires part of the ZN151 DS Box Set, which go into the CAN 6 and CAN14 slots of the DS Box. Correspondingly, the DS Box itself would need external power supply.

N.B. Please note that the cable on the pictures below is not CB012

The picture below show you where and how you need to connect the ZN057 adapter in order to read this BCM unit.