The CB030 cable is intended for bench connection with the Engine Control Units from BOSCH types

MD1 and MG1 (MRD1, MRG1) in Mercedes-Benz vehicles to

• Read and save FBS data

• Set the unit to virgin state

• Personalize with data from file (which you can read and save)

• Personalize without previously saved FBS data

• Change VIN

IMPORTANT: Units produced after 2021 are locked! You are able to personalize brand new units, not ordered for the vehicle from a dealership.

Supported Units

• BOSCH MD1 and MG1 Engine Control Units

Connection

Connect CB030 to AVDI and ZN151 DS Box - connect DB25 connector and DB15 connector of CB030 to DS-BOX. Power supply should be provided to the ZN151’s dedicated slots. ZN151 DS Box is connected to AVDI via CB402.

ZN074 can be used for providing power supply in both cases.

The CB030 has two identical connectors with different pin outs and are labeled for MG1 and MD1 ECUs..

N.B. To avoid damage or malfunction to the ECU or your AVDI, make sure you use the correct type of connector for the ECU you are working with!