This functionality allows dashboard calibration and disables the dashboard and ABS synchronisation for Nissan models 2019+ equipped with analogue and virtual instrument clusters.

NB! An internal CAN-Bus connection is required using the CB012 or CB021 Cable, depending on the UCH genaration / type.

Supported Models

• Nissan Juke F16 2019-2023 (Analogue)

• Nissan Qashqai J12 2020-2023 (Analogue + Virtual)

• Nissan X-Trail/Rogue T33 2020-2023 (Analogue + Virtual)

• Nissan Sentra B18 2020+ (Analogue)

• Nissan Skyline 2021+ (Analogue)

• Mitsubishi Outlander 2020-2023 (Analogue + Virtual)

• other models with the same dashboards (equipped with S6J329, S6J328, S6J332, S6J32L MCUs)

Functionalities

• Dashboard calibration via internal CAN

• Disables the synchronisation between the ABS and the dashboard

Procedure steps for UCH Type 1

When you are working on type 1 UCH vehicles , the CB021 cable is “plug and play” solution , created for your convinience.

1. Connect the vehicle via OBD II diagnostic port and internal CAN with the help of the CB021 cable.

2. Read the current mileage and edit it accordingly.

Example

• The CB021 should to be connected in the DS1 Connector ( Grey )

3. By writing the new mileage value the synchronization between the dashboard and ABS will be automatically disabled by the software.

Steps for UCH Type 2

UCH (SWEET 400) requires connection with the vehicle CAN-Bus with CB012 cable.

1. Connect the vehicle via OBD II diagnostic port and internal CAN with the help of the CB012 cable.

2. Read the current mileage and edit it accordingly.

Example

DS3 Green connector

• CB012 Red Needle CAN H - blue cable ( pin 2)

• CB012 Black Needle CAN L - pink cable (pin 3)

3. By writing the new mileage value the synchronization between the dashboard and ABS will be automatically disabled by the software.