Panamera 970, Cayenne 2011+, Boxster 981, 911 991, Macan Head lights start-up

This function allows you to adapt new or used headlight units to the vehicle.

When headlight is selected (left or right) and “Next” is pressed the software will examine the vehicle’s configuration and decide which steps are needed to be executed for to headlight units start-up. These steps might include: “reprogramming of the headlight control unit (left and/or right), “writing Vehicle Identification Number (read from vehicle) into the headlight control unit, automatic coding of the headlight control unit (default coding calculated on the basis of the vehicle configuration), Head Beam Adjustment calibration.

After vehicle configuration is read, the next window appears to inform the user about the preconditions which has to be met for the procedure to proceed normally.

Press “Next” to go to the page where steps to be performed are listed.

In some cases no action will be needed to start the headlights units.

In some cases there will be needed only Head Beam Adjustment calibration.

In some cases there will be needed coding, writing VIN and Head Beam Adjustment calibration. In some cases there will be needed coding and writing VIN.

In some cases there will be needed to go through reprogramming, coding, writing VIN and Head Beam Adjustment calibration.

The sequence needs to be followed as given from up to bottom. Upper steps can be skipped if they have already been performed.

In the example below all reprogramming, coding, writing VIN and Head Beam Adjustment calibration are given.

Select a step and press “Next” to execute it.

The program will inform you for the progress of the execution.