To adapt the engine control unit you need to know the existing immobilizer data of the ECU. There are three possibilities how can you get this data and adapt the ECU:

• By OBDII. Not all engine control units are able to be read by OBDII

• By flash/EEPROM dump

• By manuall entering the CS and PIN of the donor car ecu (car)

NOTE: Some engine control units don’t support the possibility to change the immobilizer data by OBDII. In such cases the procedure for adapting the ECU is finished with success, but the car is not starting. In such cases, it is necessary to make modification in the ECU EEPROM using boot mode. First need to use the “Clone ECU” function where to prepare the ECU EEPROM, then write it, then use the function for the synchronization of the ID only.

The screenshots below will show you what the procedure looks like:

1. Open the “IMMO V” Parts Adaptation menu

2. Load the immo data followed by the corresponding model

3. The adaptation has ben started

4. Data from the BCM2 unit is being read

5. The procedure has successfully completed