There are 2 ways you can directly connect to the DSM module
-
CB034 - DSM/ISM Direct CAN BUS Connection Cable - this cable lets you connect directly to the DSM connector.
-
ABProg and ZN086
The ZN086 adapter is soldered onto four points on the PCB (one of which is the lifted pin) and then connected to the ABPROG > the ABPROG is connected to AVDI, and AVDI to your laptop.
Important: The PIN that needs lifting, is specific for each processor, and you need to find that information first. Since there are many variations, you will need to do your own research and get to the processor’s data sheet. The PIN that needs lifting is the “RST” or reset PIN.
