Connections : In the vehicle by OBDII and internal CAN (diagnostic CAN) - CB012 Direct CAN-BUS/LIN- BUS Connection Cable Set is recommended!

Personalization procedure

1. Install donor TCU unit in the vehicle

2. Press “Info” button to establish connection and check status of the unit

3. Now select “Electronic Ignition Switch” and press “Info”

4. Press “Save” to save personalization data file (EIS4 data file)

5. Save the file on your PC for later use.

6. Select TCU

7. Press “Info” button to establish connection

8. Press “Personalize” and select the file with the saved EIS4 data from the EIS (make sure file type is correct)

9. Once complete, software would ask you to turn IGN OFF and ON to finalize the procedure

10. Set the VIN

N.B. Unit activation happens automatically after 100 ignition cycles.