With the use of MN030, the correction of the odometer in W205/W222/W213 and related models is now possible.

For W213 (up to 2018) and related models the procedure is done with the designated EM014 emulator, For W205, W222(up to 2018) and related models, the EM008/EM018 (old EM009) should be used.

There are two types of FBS4 instrument clusters

• IC222 – fitted in W205, W222 (up to 2018)
• IC213
• IC213 (up to 2018) – W213 (up to 2018) and related models
• IC213 (2018+) - W213 (2018+), W222 (2018+), W463 (with IC213) and related models

Models with dashboard IC222 type require emulator EM008/EM018 (old EM009)/EM014 to be installed to block the synchronization with the EZS.

Models with dashboard IC213 (up to 2018) type require emulator EM014 to be installed to block the synchronization with the EZS.

Models with dashboard IC2013 (2018+) do not require an emulator to be installed as the MN030 license disables the dashboard synchronization with the EZS.

• EM014 emulator is required only if MN029 license is used.

MN030 is also used to replace IC213 (2018+) instrument clusters – make them virgin and then adapt.

Here is the connection diagram for IC213:

Here is the connection diagram to the Powertrain (green) CAN-BUS for all other instrument clusters which have 2 CAN H-CAN L pairs:

EM008

Supported models

• W204 and related models
• W212 and related models
• W117/W176/W246 and related models
• W166 and related models
• W205 and related models
• W222 (up to 2018) and related models
• W447

EM009

• It comes equipped with a cable set (jumper)
• which is used to connect to the cluster directly.

Supported models

• W204 and related models
• W212 and related models
• W117/W176/W246 and related models
• W166 and related models
• W205 and related models
• W222 (up to 2018) and related models

• W447

EM014

Supported models

• W204 and related models
• W212 and related models
• W117/W176/W246 and related models
• W166 and related models
• W205 and related models
• W222 (up to 2018) and related models
• W447
• W213 (up to 2018)
• W463 (with IC213) (emulator is not required if MN030 is used)

EM018

The ABRITES EM018 emulator is designed to assist the odometer calibration when this cannot be done by diagnostics.. It comes equipped with a cable set (jumper) which is used to connect to the cluster directly.

Supported models

• A-class/GLA-class (2012-2019) – W176, W117, X156 and related models based on the same platform
• B-class (2011-2019) – W246 and related models based on the same platform
• C-class/GLC-class (2007-2021) – W204, W205, X256 and related models based on the same platform
• E-class (2009-2016) – W212, W207 and related models based on the same platform
• M-class/GL-class/GLE-class (2011-2018) – W166/X166 and related models based on the same platform
• S-class (2013-2018) – W222 and related models based on the same platform
• Vito (2014+) – W447 and related models based on the same platform

Red - 12V+
Brown - GND

Dashboard connector legend:
Purple/White - CAN H
Purple - CAN