Reading and registering Injector codes is very important when the user is faced with the need to replace the Subaru diesel injectors.

Required equipment

• Abrites AVDI interface connected over OBDII
• Abrites Diagnostics for Subaru software
• The codes of the replacement injectors

Step-by-step procedure

1. Enter the engine control unit

This is done by entering the Engine control unit's menu.

2. Select INJECTORS and read

Once that is done the user should select "INJECTORS" and read the injector codes.

3. Save the codes

Then they should be saved.

4. Register the injectors

The injectors should be registered and the vehicle will start.

Important notes

• Read and save before replacing. The stored codes are the reference point if anything goes wrong with the new set.
• An unregistered injector set is a common cause of a non-starting engine after a replacement job - registration is not optional.