This connector is used if you do not own a particular adapter used with the ABProg, thus, you will be able to make your own adapter as per the task required.
Here is how to use the DB25 adapter as some of the additional adapters intended to work with ABProg programmer:
DB25 Connector
The DB25 pin numbers for the same wires are listed on the DB25 Male Connector page.
ZN046 PIN OUT
| DB25 pin | Signal | Wire |
|---|---|---|
| PIN 1 | - | Red wire |
| PIN 2 | - | Red wire |
| PIN 3 | - | Red wire |
| PIN 4 | - | Red wire |
| PIN 5 | RX | Green Wire |
| PIN 6 | TX* | White wire |
| PIN 14 | GND | Black wire |
38K resistor between PIN 6 and PIN 14
ZN058 PIN OUT
| DB25 pin | Signal | Wire |
|---|---|---|
| PIN 5 | RX* | Purple* wire |
| PIN 6 | TX* | Purple* wire |
| PIN 13 | FLMD0 | White wire |
| PIN 14 | GND | Black wire |
| PIN 20 | +5V* | Red wire |
| PIN 25 | Reset | Green wire |
10K resistor between PIN 5 and PIN 20, and a 1N4148 led between PIN 5 and PIN 6
ZN078 PIN OUT
| DB25 pin | Signal | Wire |
|---|---|---|
| PIN 5 | RX* | Purple* wire |
| PIN 6 | ТХ* | Blue wire |
| PIN 13 | FLMD0 | White wire |
| PIN 14 | GND | Black wire |
| PIN 20 | +5V* | Red wire |
| PIN 25 | Reset | Green wire |
ZN086 MC9S12 ADAPTER for ABPROG
| DB25 pin | Signal | Wire |
|---|---|---|
| PIN 14 | GND | Black 0.25 |
| PIN 21 | +5v | Red 0.25 |
| PIN 11 | RST | Yellow 0.11 |
| PIN 19 | BKGD | Green 0.14 |
Important notes
- The resistors are not optional. ZN046 needs the 38K between PIN 6 and PIN 14; ZN058 needs the 10K between PIN 5 and PIN 20 plus the 1N4148 between PIN 5 and PIN 6.
- Note the ZN078 difference from ZN058: TX moves from a purple wire to a blue one, and there is no resistor or diode.
- The power from the ABPROG is 5V DC - size your wire and check your work before applying it to a target PCB.