Abrites ECU Programming Tool - reading and writing engine and transmission control units by OBD, bench and boot
Reads and writes Internal/External Program Flash, Data Flash and Maps of ECUs and TCUs, with checksum correction, over three routes: DIAG (OBDII), Bench (direct to the unit's pins) and BSL (boot mode).
Required equipment
- Abrites AVDI interface with an active AMS
- ZN151 Distribution Box - required for Bench and BSL
- ZN074 - ECU reading set - for powering the DS Box on bench
- CB401 or CB403 cable set, CB402 to the AVDI
- CB023 (BMW MD/MG), CB030 (Mercedes MD/MG), ZN079 (ZF 8HP, DQ381)
IMPORTANT: In order to use the ECU programming tool the AMS should be active and the hardware update should be performed at least once a month. For more information please open the Abrites Common User Manual.
Licences
| Licence | Covers |
|---|---|
| EP001 | Bosch EDC17/MED17, Delphi, Continental/Siemens SIMxx, Kefico - by bench, boot and OBDII |
| EP003 | MD/MG ECUs and VGS2-FDCT / ZF 8HP / DQ381 / VGSNAG3 / Getrag 7DCT300 TCUs on bench |
| EP005 | ECUs and AdBlue modules in trucks, motorbikes, boats and industrial vehicles by OBDII |
Contents
2. Using the Abrites ECU Programming Tool
2.1 Connection to the ECU using ZN151 Distribution box:
2.2 Using the CB403 (CB401) cable from the ZN151 set
2.3 Using the CB403 DS-BOX Extended Cable Set
4.1 Supported units for bench reading:
6. ZN151 (Distribution Box) connections
8. ECU Connections - PIN OUT Diagrams and Boot
9.2 Mercedes VGSNAG3 9G-tronic
10. ZF 8HP Virgin - Adapt for BMW
11. DQxxx TCU On-Bench Pinout's
12.1 Mercedes CEPC unit reading by OBDII