The ZN085 bench programmer for RH850 and V850 MCUs - reading immobiliser data, mileage calibration, key programming
The Abrites ZN085 programmer reads electronic units equipped with RH850 or V850 processors, and writes those equipped with V850. It is the way into dashboards and BCM modules whose data cannot be reached over OBDII - VAG instrument clusters, and Renault, Nissan, Ford and Fiat body control modules.
Coverage: the supported unit list is dynamic and constantly updated. Check your own part number in the software with the "Check by Part Number" button before planning a job.
Supported operation: reading is supported on RH850 and V850; writing on V850. Most procedures finish in another Abrites application - the programmer reads the unit and uploads the data, then the brand software does the key programming.
Required equipment
- Abrites AVDI interface
- ZN085 Abrites programmer for RH850/V850
- CB501 RH850/V850 connection cable, and soldering tools
- CB503 NCF Connection Cable
- Windows 10 or later - see Requirements
- The licence for the job in hand - see Additional licenses
Contents
1. Introduction and 2. General Information
2.3 Additional licenses required for completing the job
2.4 Additional Important Information
2.5 Frequently Asked Questions (FAQ)
6.2 Reading a Ford (2021+) BCM module with an RH850 mcu
7. MQB RH850 with Visteon/JCI dashboard mileage changing
8. Calibration for Instrument Cluster Types IC223/IC177M
9. BDC2/3 Spare Key Programming on Bench NFC
10. MQB 5C/5D Immo Data Reading from NCF Processor